Zk-pp2k Manual < Safe >

For high-current applications exceeding 5 Amps or when operating at high frequencies like 20kHz, it is recommended to provide additional cooling for the MOSFET output stage to ensure reliable operation.

How long to wait after pressing "ON" before the signal starts. Number of Pulses:

Press the ON button to ensure the output is activated.

The is a high-power dual-mode signal generator capable of driving loads up to 8A directly, such as motors, LEDs, or solenoids. Key Specifications Zk-pp2k Manual

The ZK-PP2K PWM Signal Generator Go to product viewer dialog for this item.

: Ideal for dimming, speed regulation, and electromagnetic valves. PULSE Mode : The screen does not display "%".

You can switch between two primary modes at any time. Detailed manuals are available from Ledsales and Supereyes . 1. PWM Mode (Indicated by "%" on screen) For high-current applications exceeding 5 Amps or when

I can provide a custom wiring diagram and parameter settings tailored to your project. Share public link

: Positive load terminal. Note: VIN+ and OUT+ are directly bridged inside the module.

Maximum output current of 8A (approximately 150W). Frequency Range: 1Hz to 150KHz with an accuracy of 2%. Duty Cycle: Adjustable from 0.00% to 100% in 1% steps. The is a high-power dual-mode signal generator capable

"The Manual," Kael said dryly. "I found it in the previous owner's pocket. I thought I’d see if you could figure it out on your own. I see I overestimated you."

DC 3.3V to 30V (output amplitude matches input) Current Capacity: 8A maximum (high power) Frequency Range: 1Hz to 150KHz (2% accuracy) Duty Cycle: 0.00% to 100% Pulse Count: 1 to 9,999 or Infinite ( ---- ) Time Range: 0.000s to 9999s for delay and pulse width 🛠️ Quick Operation Guide Switching Modes Toggle PWM vs. PULSE: Hold the SET button for 6 seconds . PWM Mode: Identified by the % symbol on the screen. PULSE Mode: The % symbol disappears. Mode 1: PWM Mode (Continuous Signal) Use this for simple speed control or dimming: FREQ+ / FREQ- : Set the frequency (1Hz–150kHz). DUTY+ / DUTY- : Set the duty cycle (0%–100%). Mode 2: PULSE Mode (Cycles & Delays) Use this for specific pulse counts or timed bursts: Positive Pulse Width: Set using P+ and P- . Negative Pulse Width: Set using N+ and N- . Start Delay & Pulse Number: Hold SET for 2 seconds until "SET" appears at the bottom. Use P+ / P- for the Delay Time .