Stanley Fatmax Stud Finder 400 Manual Verified

This page contains a downloadable PDF attachment of the manual, which you can save and print for future reference.

: While magnetic models aren't affected by "free hand" interference like electronic ones, ensure you aren't scanning over metallic wallpaper or foil-faced insulation, which can cause erratic readings.

If you start the calibration directly over a stud, the device will "auto-zero" incorrectly. It will then beep everywhere except the stud. If you suspect a mistake, lift the device, move it 12 inches to the left or right, and repeat. stanley fatmax stud finder 400 manual verified

Place the stud finder . Do not touch the wall with your fingers near the sensors. The manual states: “Hold the unit by the thick rubber grip only. Fingers on the faceplate affect capacitance.”

A: Usually, this is caused by low battery or improper calibration. Replace the 9V battery and ensure you are holding it flat against the surface before pressing the button. This page contains a downloadable PDF attachment of

: The scan depth of 1½ inches refers to scanning through drywall or plasterboard. Scanning through thicker or denser materials can produce inconsistent results.

Stanley FatMax Stud Finder 400 Go to product viewer dialog for this item. Manual: Verified Instructions & Expert Tips The Stanley FatMax Stud Finder 400 It will then beep everywhere except the stud

Remove the battery if storing the tool for more than 30 days to prevent corrosion.

Wait 1 to 3 seconds until a single solid beep sounds and the appears on the LCD screen. Calibration is now complete. Step 2: Tracking and Marking Stud Edges 77-730 FatMax Stud Sensor Instruction Manual

The official instruction manual for the Stanley FatMax 400 outlines the following precise steps for scanning and calibration:

Grip the handle firmly. Keep your fingers away from the sensor pad area on the bottom of the device.