When integrating the controller with a single-point weigh frame (such as the ), ensure the following physical parameters are maintained:
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. CST Mavis-ICS-Arm Cargo Superintendent Scale - Blackwoods
To consistently maintain regulatory custody-transfer ratings (e.g., National Measurement Institute Class 0.5 , Measurement Canada 0.1% , OIML Class 0.5 , and NTEP 0.25% ), operators must carry out systematic calibration sequences: Stored-In-Place (SIP) Calibration Masses mavis-ics-arm manual
Disclaimer: This article is for informational and educational purposes. Always refer to the official, factory-supplied MAVIS-ICS-ARM manual for your specific hardware revision before performing any installation, programming, or maintenance operation.
Integrates one or two automated flow controllers to adjust material throughput on active lines. When integrating the controller with a single-point weigh
To reintegrate with the ICS, go to Section 11.1 (Volume II) – "Relearning the Soft Limits." Action: The manual provides a Python script snippet for the MAVIS CLI: mavis_ics --set-joint-limit J2 -170 to +170 .
: Ensure no rogue rocks or materials are jammed between the high wing idler clearance zones and the conveyor stringers. Can’t copy the link right now
: Check the spring tension on the Model PPC tachometer underneath the belt. Tighten if the friction wheel shows signs of slipping or skipping during heavy material startup loads.
Save the calculated zero value. The deviation between consecutive zero trials should not exceed . Step 2: Span Calibration Options
Supports up to 4 precision shear beam tool-steel or stainless steel load cells (IP67 protected).
This value updates in real time, as a running average per cargo hold, and as a total cumulative average for an entire vessel. 5. Operation, Event Logging, and Legal Certification