Life Probo Pr70 Instructions For Installation Use And Maintenance Manual 10 Pages Work !exclusive!

to move the door by hand. To re-engage, return the door to its original position until it "clicks" back into the transmission. Maintenance Safety Checks : Periodically check that the obstacle detection is working. You can adjust the sensitivity by holding the red button for five seconds and using the plus/minus keys.

If you encounter issues with your Life PROBO PR70, refer to this troubleshooting guide.

measures roughly 10mm from the rail profile. Attaching Motor to Rail Align motor shaft with the drive sprocket inside the rail. to move the door by hand

Regularly test the obstruction sensitivity. If the door meets an obstacle, it should stop and reverse immediately. 6. Safety Warnings This product is for professional installation only.

Route low-voltage signaling lines (e.g., photo-eye sensors, wall push-buttons, flashing warning lights) through the dedicated entry knockouts. You can adjust the sensitivity by holding the

Determine the center of the door and mark it on both the door and the ceiling.

Built-in encoder for obstacle detection and a manual release mechanism. 2. Installation Guide Attaching Motor to Rail Align motor shaft with