Everstart Battery Charger 60108m Manual //top\\ Instant

Ensure your 6V/12V switch matches the physical battery type.

Identify the positive ( + , Red) and negative ( - , Black) battery posts.

Let the charger run on its highest standard charge setting before attempting to start. This puts a surface charge on the battery and makes starting easier on the equipment. everstart battery charger 60108m manual

Once the charging is complete (or maintenance mode is on), turn off the unit, unplug from the wall, and remove the clamps. Common Issues & Tips

A mild hum and warm housing are normal for large manual transformer-based chargers. Ensure your 6V/12V switch matches the physical battery type

: Use the buttons on the front to select the desired charge rate (2A, 10A, or 25A) and battery type.

: If you must remove the battery from a confined vehicle space to charge, always disconnect the grounded (negative) terminal first. This puts a surface charge on the battery

Leave on 2A charge for 24 hours; if needle doesn't drop, test or replace the battery. Normal transformer operation or internal fault Ensure unit is placed on a flat, vibration-free surface. 🧹 Maintenance and Storage Proper care ensures your wheeled charger lasts for decades.

Ensure the wall outlet has power by plugging in another appliance.

Once finished, unplug the charger from the wall first, then remove the black clamp, followed by the red clamp. Troubleshooting and Error Codes

Before plugging in your device, it is important to understand the hardware profile and power requirements of the EverStart Plus 60108M unit 120V AC Standard Wall Outlet. Output Voltage: 12V DC. Amperage Multi-Modes: